Inside door panel

[Bouchie11982]

OK, im am trying to take off the inside back door panel of my 94 GA SE 4 dr. and i cannot get the damn thing off :( ive taken out all the screws and i still cannot get it off...the only part that isnt coming off the greatest is the top area with all the fabric on it. i dont know if i am not lifting it up righ or what? but anyone got any suggestions on how i can get it off...the reason is cuz i need to wire the hot wires through that black accoridna looking tube so nothing hangs out. and then i can run it along the area where i have my power wire for the amp etc. etc.....so i am hoping to GOD that there is someone out ther that can help me with this ...
:((

[ramairgt2]

there are clips inside the door panel on the top. you have to roll down your window all the way and then lift up and pull at the same time ... kinda tilt the panel upwards. my 93 was the same way and so is my 91 so that should help you out. Just becareful not snap anything off.. I hope this helps you out

Jr

[speedemon]

ive actually been doing this for the last few days on my 97, so hopefully its the same as yours.. first make sure all the clips on the bottom and side are pulled out. on the top of the door it has some kinda hooks that hang on to the door and to get them out, you have to push on the inside panel outward, while pushing up from the bottom of the panel. its kinda complicated to explain, but once you see what they look like and how they work its ez. just try and take a lamp and look inside your panel and find these hooks and see how they are holding onto the door.

good luck;)

if u have any more questions just pm me, and ill try and get you some pics. :D