procarparts gauges

[Danv6]

i know ive asked this before but the gauges slide over the needles? and you don't have to take them off? somehow it just seems like the needle will break or something while sliding them on...im going to do the gauges within the next few days most likely..i haven't had time to until now.....any tips would be great.....thanks

[illsmokeyou]

yes they slide right over... DO NOT remove the needles

[Danv6]

im sorry...if i keep bothering you or whoever i just don't understand how they would but im sure when i do it ill figure it out..i really appreciate the advice tho...thanks man lata

ill post after i have them in

[illsmokeyou]

no problem.... you can AIM me for step to step processes, its just that I couldnt stress enough the need to NOT move the needles. ;)

then major calibration problems will arise

[Danv6]

aight thanx for the help i got them in and they look pretty good...the only thing is that the top two small pieces didn't line up perfect they aren't exact but good enough for now...but they look nice..thanx for all the help

lata