Canci run 2 sws1241d's at 2 ohms?

[Ghostgt]

I know that they are 4 ohm dvc, and i was wondering if i can run them at 2ohms and if i should bridge them, or how i should wire them? By the way i will be running them off a Profile CL800.

[btchn1]

On each sub you have two sets of terminals. On each set there is a positive (red) and a negative (black). Hook both positives together and take them to the positive of one channel of the amp. Then do the same with the negatives. Now do all that for the other channel of the amp. You are now running in two ohms stereo. DO NOT BRIDGE THE AMP TO THESE SUBS! Take my word on this the amp will hate you for it and then die. Peace out, Lee If you need a picture just pm me your e-mail address and I will send you one.

[Ghostgt]

So can i take a regular speaker wire and split them into two at the end and run them to each terminal on the sub and just connect the amp with the other end with both wires together?

[btchn1]

I beleive you are on the right track. there should be pictures on the subs spec sheet and should be more drawings in the amp book. Lee

[nineteen88ga]

You can even go to Alpines web site to see different ways to wire up the subs.

www.alpine-usa.com

[Ghostgt]

Hey thanx for the link didn't even think of it! ;)