redbaron231
11-24-2003, 12:53 PM
I got a 1992 pontiac grand am gt with a 3300 vg automatic, i got a custom enclosure audio system , with brembno brakes , tenzo tires and inky rims "6 spoke black gunmetal" i got dual greddy catback exhaust, i need some more ideas and i also have acouple tips and tricks of my own , if u got a Gt in the 90's u can remove ur turn signal and front bumper lights and replace them with red,green,blue or what ever u like and it really sets the car, also i made my own clear tailights, this Mod requires the following, 1 set of 92-95 Grand Am Gt taillight assemblies,small flat head screwdriver,hair dryer and maybe some epoxy for the re-seal , first remove the tails from the car !, then turn on the hair dryer and slowly move it acros the epoxy seal that fits between the bulb caseing and the lense of either assembly,after it is heated up , slowly pry the flat head screwdriver between the lense and the caseing. ( move along the entire assembly in a step by step motion have ing the hair dryer on the spot ur working , doing it this way will reduce the risk of cracking the lense!) after you are finshed prying the lense apart from the bulb caseing it should fall off, the the two possiblities are the first is there will be a red film over the lense, if this is the case you will have to peel the film off the lense to make it clear, the second is the way mine were there is a red plastic piece covering the lense if you see this then just pry it up apart from the lense , once you are done with one side do the next, after both are apart it is time to reattach the lense to the caseing , you can either use the existing apoxy or redo the entire assembly with new, if using the old apoxy, i would re-heat the glue with the hair dryer before attaching , this way it will attach tighter and you dont have to worry about them fogging up, then after both sides are finshed put both back on car, once they are on you will need either red bulbs,clear bulbs with red covers or red leds or pipe couplers that are alittle bigger than the bulb and some red reflectors and glue the couplers over the bulb and then put the refecter glued to the end of the coupling. thanxs alot and i hope u can give me some ideas or thoughts for my car-Jay