neon wiring

[firebirdsmoker]

can i splice the neon wires into lets say the accent lighting under my dash on the floor? or must it go into the fuse panel? and if it does how do u do that? any help is appreachiated, thanx

[phat01gagt1]

are u putting the neon on the inside of your car ???

[firebirdsmoker]

yes, i'm gonna put 2 9" along my center console and then a big 20" on my rear deck lid....hope that helps ya help me some

[RocketFast321]

you might can get away with 2 i don't know about 4. Try it and find out, if a fuse blows you have to many neons

[firebirdsmoker]

is there a better way to wire it in then? i'm gonna wire in a switch to let ya kno i just wanna kno if the accent light wires or the fuse box will be better and if fuse box which fuse i should go with....

[ccarr8705]

If you dont use your Cig Lighter just use the wires to that. It is way simpler and easy to wire to a switch.

[Aaron]

Do you mean the courtesy lights in the footwell? You want the neons to come on when you open the door basically? I did that and can tell you how if you want.

[firebirdsmoker]

lay it on me, how do i do it? plus i wanna make the one on the deck on a switch so wheres the best wires to tap into for that?

[jazzman]

when i did it, i took a line directly off the battery. Ran it through a hole i drilled in the firewall a while back for my remote start. Then i put a ground on the drivers side in the engine(the bolt was already used for a ground in the engine). I took the two wires through the firewall, spliced it into three seperate +, and three -, connected each + and - to a switch, then connnected the neon to the switch as well, grounded the neon on the switch and we were set. pm me if you have any questions since we live in the same town. I could help.

Derek