decisions decisions

[VanishingImage]

Im holding off on buying a new exhaust til I get the AAS kit because its a dual exhaust rear so im going to go dual after I get it.My question is should i stay at 2 1/4 piping(2.25'') or go 2 1/2 piping? Im basically wanting deeper sound but keep power at the same as it is now if possible.I am going with a Flowmaster 40 original series on my 2.4 after i get the kit so right now i just need to know what size piping i should go with.I have no resonator so thats not a problem,i had it taken off when i went to 2 1/4 piping.

[Xidion]

2.5 i belive and id go borla personaly i think the SLP sounds to raspy

[VanishingImage]

would Borla sound deep enough on a 4cyl? I mean I've heard a couple Neons around here with it and they sound alright til they get up in the upper RPM's then it sounds raspy.

[Matt95GT]

If you are running a 2.4 with auto, stay with 2.25". Reasons:
-retain low-end torque (a good thing on auto)
-less raspy

Yes, Borla sounds good too. High-RPM raspyness is a characteristic of a 4 cyl and is not completely avoidable.

[VanishingImage]

ok thnx guys.....Borla was one muffler I was looking at but the $$ kind of detered me a little bit but I think i have my answers on buying it now.

[Matt95GT]

Originally posted by VanishingImage
ok thnx guys.....Borla was one muffler I was looking at but the $$ kind of detered me a little bit but I think i have my answers on buying it now.

Check out ebay. There's a shop selling loads of them. I picked mine up for $75 a piece. :thumbup2: