setting up my amp

[zero53121]

i just got my mrd m300 back from alpine and it works great but i need help on setting it up. i have 2 12" alpine type e's

[Lebult]

What do you need help with?
Wiring?
Enclosure?
Amp adjustments?

[zero53121]

amp adjustments

[Pte Socks]

hmm.. crap, cant remember what my amp is set at. If your still wondering after tonight, ill check out my settings tomorrow and tell you them

[Lebult]

I just turned down all my gains, and turned up the volume to what I usually listen at, then started turning the gains up until it sounded good.

[matts]

it's a digital amp, they have to be set a different way

[Pte Socks]

yea, way different, sorry man, its too late to start up my car and chekc it out, but I promise ill send you what I have tomorrow

[Pte Socks]

ok here is the setup I have on my amp, bear in mind this is for my subs and what I like I music, yours most likely will be different

Input mode
1-1 = 2ch
-2 = 0dB
Low Pass Filter
2-1 = on
-2 = 95 Hz
Subsonic Filter
3-1 = on
-2 = 20 Hz
Parametric EQ
4-1 = on
-2 = 45 Hz
-3 = 2
-4 = 12 dB
Bass Comp.
5-1 = on
Time Corr.
6-1 = off
Phase
7-1 = 0
Amp Set
8-1 = 1
-2 = 0.0
Safe Mode
9-1 = off

Ok there you have it, my setup.

[zero53121]

thanx alot i probably take ur settings and adjust it from there. the only problem i have is that i have nowhere to crank my music and adjust the amp... i wish i had the controller for the amp that would be awesome.

[Pte Socks]

hehe I hear you on that, thats the problme wiht rattles, you ahve to blast it to find them but it pisses neighbours off if you do.. anyways, gl on the setup