How to: Installation of the Jet Performance Module, 3400 V6

[Old Guy]

This is the way I found it works best regardless of what the instructions say. They say to connect the red (hot) wire to a switched source. That will give you an SES light.

1. Connect the red wire to the positive terminal of the fuse box under the hood. (If there's no in-line fuse, buy one and attach it between the red wire and the positive terminal.)

2. Connect the Black wire to a good ground. I used a bolt on the fender well.

3. There is a Dark Blue wire on the TPS (Throttle Position Sensor). The TPS has 3 wires going to it. Strip about 1/4 inch of that wire. Don't cut it. Connect the Brown wire to it, solder, and tape it off.

[Old Guy]

4. The next part is the hardest. If you look in front of the coil packs and behind the upper intake you'll see a black box. That's the MAP sensor. Remove the box carefully by taking out the 2 screws and move it off to the side. You can disconnect the small vacuum line. Now cut the Light Green wire. There's not much to play with so be careful. Solder and tape the Grey Wire onto the wire that's still attached to the MAP Sensor. Solder and tape the Green Wire to the other wire.

5. Screw the Map Sensor back on.

You can leave the Jet Module on....it will turn off by itself. It doesn't need to be on a switched source.

http://www.gaownersclub.com/forum/attachment.php?s=&postid=312131