PDA

View Full Version : flipping down the backseats?

tdub4life
10-11-2004, 04:39 PM
ok, i know there is a way to flip them down in my '01 SE, but I must be missing it or something.... call me a newb, but can someone PLEASE tell me how to flip my backseats?

:idunno: :roll: :shrug:

I'm sorry now if it's obvious ;)
CuztimGASE1
10-11-2004, 06:31 PM
in ur trunk, as soon as u open it, look under where ur speakers would be and there is too little nylon straps. pull those and ull hear a pop and that is ur seats bein unlatched, then just push em down
tenspeed
10-11-2004, 06:38 PM
That, of course, is assuming that you actually have a rear seat that flips down. My '02 GASE does not have that feature.
tdub4life
10-11-2004, 07:01 PM
Originally posted by tenspeed
That, of course, is assuming that you actually have a rear seat that flips down. My '02 GASE does not have that feature. Hmm.... what's the obvious clue that it doesn't have that feature? No straps? The dealer never specified when I first bought it.
StaindGreen9
10-11-2004, 07:28 PM
I don't know on yours, but mine doesn't have fold down seats. I have three clips (one on the left, one in the middle, and one on the right) that I had to unhinge with the back seat to fold it down. It was a PITA to get them back in though... It was nice having it like that when I had my system. The next car I buy I will make sure it has fold down rear seats.
Subtle_Cynicism
10-11-2004, 08:14 PM
I would say you don't have this feature if you do not see any type of pullcord in your trunk area.
tdub4life
10-11-2004, 09:55 PM
Originally posted by StaindGreen9
I don't know on yours, but mine doesn't have fold down seats. I have three clips (one on the left, one in the middle, and one on the right) that I had to unhinge with the back seat to fold it down. It was a PITA to get them back in though... It was nice having it like that when I had my system. The next car I buy I will make sure it has fold down rear seats. This I may have to do, in order to clean up my wiring and get everything set and bolted in on my amp. I see clips back there, though I know I don't have the same model as you. What was the easiest way to unhinge the clips?