Cai

[AeR0]

is it worth spending the money on a CAI ?


what have u guys done for your induction setups?

[Goldfever]

www.induction-dynamics.com I have their CAI and am very satisfied. It kinda cost a lot but I found it was worth it to make my engine breath better.

[AeR0]

now if i live in a colder climate.. like say right now here in ontario am i best to leave it on all year round or should i put my factory air box back on in the winter?

[Goldfever]

I am not really sure about the winter conditions because I have only seen snow twice in my life, but this intake is produced and tested in the Canadian winter. I think it says that somewhere on the website. But your asking the wrong person about winter conditions.

[AeR0]

lol i thought so enjoy your heat while i enjoy the damn cold!


j/k

-6C out today thats warm!

:D :)

[kickarsgrdam01]

i live in IL and we get snow here, i leave my CAI on year round..mostly because i am WAY to lazy to take it off

[AeR0]

lol ...

im just in the process of buying a new motor so i want to treat this one better thats why i asked that question because im looking at getting a CAI

[DoubleOZeroGAse]

Why did you have to replace the motor of a '99?

[AeR0]

check over in the problems and solution section i got a big post on it over there!

:D

[DrFabulous]

CAI is nice to have on these engines, especially mated with some exhaust. If nothing else, get some sort of short-ram intake and put a Civic air intake on the end to make a CAI, and then you can take the bottom part off for the winter, if you're worried about snow. I live in northern MN, and that's the route I'm going.

[DontPassTheFence]

Id say the Inductions Dynamics, ive heard nothing but good things about their CAI, but there is also plenty of WAI's for the 2.4L Cavys/Sunfires that will fit perfectly in the GA.

[mthegodfather]

Intake (http://www.cosmoracing.com/default.asp)

Check out cosmo racings intake for the 2.4 sunfire. I have there evoulution intake and it kicks ass. It is just like the RSM intake for half the money.

[mthegodfather]

Remember bent metal pipe is bent metal pipe.

[DontPassTheFence]

lol ^^ definately.. as long as said metal piping has the fittings for the sensors, im all for it

[DontPassTheFence]

one unrelated question, is the short shifter listed for the 00-04 sunfires for the izusu tranny (mated to the LD9) or for the getrag (mated to the ecotecs) ??? I really want a short shifter, but they dont make one for the stupid izusu tranny...