rear cylinder head removal

[95blackz26]

ok whats the easiest way to remove the rear cylinder head w\o removing the motor mount bracket. cause as of right now i cant the bracket off. ive tried everything beating the hell out of it. nuts wont budge.

[startacv6]

Well i just changed mine about 2 days ago and I had to remove the power stering pump and the lower bolt to that is right underneath the motor mount bracket, here is what i did grabbed a can of PB Blaster and sprayed the crap out of it and let it sit for a day then spray it again and then let it sit for a bit then give it a try again, and if all else fails try using a hand held torch and heat them up. The worst part of it is you have to take the lower intake off as well because of the way the gaskets are. And when you put it back toghter remeber to put the lower intake gasket on first then put in the push rods and tighten the rockers down to 18ft lbs with a 70 degree turn. sorry but the motor mount bracket has to come off.