Wallflower
03-28-2003, 06:34 PM
Well, my first mod is officially complete. The PowerSlots are on the car and working wonderfully so far. I want to bleed the brakes tomorrow when my brother is around. But all in all, I am very satisfied. :thumbup2:
Something I noticed on my original brakes ... the rear face of the rotor was not getting full contact from the pad. The front was wearing fine, but the backs were not. Only the bottom half of the pad was providing friction. I have a ring of about 1 inch wide, from the outer edge of the rotor toward the center where the pad didn't touch at all. This area was actually rusted. The matching pattern is also on the rear pad. I will note that it was on both sides of the car too.
Anyone get the same ??:penny:
Something I noticed on my original brakes ... the rear face of the rotor was not getting full contact from the pad. The front was wearing fine, but the backs were not. Only the bottom half of the pad was providing friction. I have a ring of about 1 inch wide, from the outer edge of the rotor toward the center where the pad didn't touch at all. This area was actually rusted. The matching pattern is also on the rear pad. I will note that it was on both sides of the car too.
Anyone get the same ??:penny: