View Full Version : coil tower/pack/ sparkplug
Synthetic01GASE
05-02-2006, 12:39 AM
Okay 3 times this month my coil tower has been replaced, the first time the coil tower and packs were replaced along with the spark plugs... and almost every 2 weeks they have went... the only other read error i get is about the cadalytic converter, but thats b.c the carbon inside it is comming undone. i was wondering if anyone would have some insight on this issue
pokesmot
05-02-2006, 08:17 AM
are you replacing the coil packs individually, or are you replacing it as a whole unit? (coil packs already mounted on the ignition module)
try going to a scrap yard and buying and ignition moudle with coil packs thats been tested already, should set you back around $100 with a 3 month warranty.
also try grinding off any rust thats formed on the plate where the ignition module mounts to the engine. clean the bottom of the ignition module and the bracket plate so that there is good conductivity.
Also check your wires and make sure they arent frayed, melted, or visibly damaged in any way.
examine the connector that plugs into the ignition module for corrsion and replace it if its rusted out.
Synthetic01GASE
05-02-2006, 03:57 PM
okay, everything looks fine, car seems to be running fine. so hopefully it doesnt happen again
vBulletin® v3.7.3, Copyright ©2000-2008, Jelsoft Enterprises Ltd.