Can somebody help me out here.

[01_grandam]

Help me out by posting some pics of the install of your undercar lights. Don't want pics of them on just daylight pics under the car so I can see where to mount them at and get the best glow.

[RickHigginsHtbr]

although i havent done it personally, your going to want to mount them where the tubes themselves can't be seen. like, don't mount them on the rockers, but on the inside of them... and the front + rear bumpers, your going to want to mount them on the insides of the bumpers, although i have seen the front mounted on the radiator, lit up nicely, but it was obvious it was there. do a search man, i know the threads weren't recent though.

[LittleWhiteGT]

I have under bodys on my neon and was thinking for transfering them over to the pontiac. I have a 99 and after a quick look I found that the sides have a nice mounting spot under the car a bit that tucks it up and out of the way, the rear was a little bit diffrent and I dint real see any good spots to put it and the front was even worse there was no real spots that the tub it self would not be visible. it also looks to be a pain to run it wires threw the car. I to would like some ideas of mounting locations for the lights and mabye sugestions of running the wires

[Eden]

I have the '92 so i am not sure if this will help, but I put Underglow on my car last week. The 48' tubes go on lip on the underside of the car. When you look under the car on the sides there should be a lip, drill holes and mount them there. The tube in the back is on the very edge of the rear bumber, I ran zip ties around the metal bumper and tied it in. The front was annoying I just drilled holes in the bottom part of the bumper, and zip tied, but I figure after I get the Mesh in there it won't matter. With the wires, I ran the rear behind the bumper, and between the quarterpanel and the tail lights, then into the trunk and through the cab, under the weather stripping. The other wires are easy to run. I will try to post pics later.