gt271
05-01-2003, 10:01 PM
parts needed: 1 apc civic/integra intake(you can find them at most autoparts stores), 1 3inch diameter 90 degree elbow, as many different 3 inch diameter tubes as possible, 5 clamps, 1 cone filter
Step 1: take out air box and all tubing leading down into the wheel well and back to the maf.
Step 2: dissconnect and remove battery and the plasic piece it sits on.
Step 3: take out all screws for the front left side of bumper all the way up into the wheel well as a side note you may have to remove the front tire.
Step 4: at this point you should be able to pull the plastic down enough to slide the cone into place right up against the wheel well. do this.
Step 5: slide the tube from the intake you bought down into the bumper and connect it to the cone filter clamp it into place.
Step 6:put battery back in, do not connect yet though, make sure youv got the tube pointed where you want it and connect the 90 degree elbo to this( a rubber elbow works best but if you have to you can use pvc pipebut if this is the case youll need a rubber slip to connect the two being that they are both solid)
Step 7: connect the last piece of tube from the elbow to the maf
clamp in
Step 8: reconnect bumper and battery and your ready to go
if you have any leeks duct tape should take car of it and if your car is equpped with theftlock on the radio make sure you know the code hope this helps any one who was wondering how
Step 1: take out air box and all tubing leading down into the wheel well and back to the maf.
Step 2: dissconnect and remove battery and the plasic piece it sits on.
Step 3: take out all screws for the front left side of bumper all the way up into the wheel well as a side note you may have to remove the front tire.
Step 4: at this point you should be able to pull the plastic down enough to slide the cone into place right up against the wheel well. do this.
Step 5: slide the tube from the intake you bought down into the bumper and connect it to the cone filter clamp it into place.
Step 6:put battery back in, do not connect yet though, make sure youv got the tube pointed where you want it and connect the 90 degree elbo to this( a rubber elbow works best but if you have to you can use pvc pipebut if this is the case youll need a rubber slip to connect the two being that they are both solid)
Step 7: connect the last piece of tube from the elbow to the maf
clamp in
Step 8: reconnect bumper and battery and your ready to go
if you have any leeks duct tape should take car of it and if your car is equpped with theftlock on the radio make sure you know the code hope this helps any one who was wondering how