View Full Version : Problems....
DUSTIN4537
02-07-2007, 04:30 PM
I JUST CHANGED MY IGNITION. NOW SHE DOESN'T WONT TO START UP.
IT SOUNDS LIKEEE SHE WANTS TO TURN OVER BUT IT GIVES
AND
IF I TURN MY WHEEL TO THE RIGHT THE ABS...TRAC OFF...AND SERVICE VEHICAL SOON COMES ON^
SOMETIMES ABS LIGHT DOESNT TURN ON UNTIL MY LEFT TIRE MAKES A GRINDING SOUND THEN IT COMES ON
MY BLINKER CLICKS RAPIDLY WITH NO SIGNAL LIGHTS COMING ONWHEN I JUST TOUCH THE TURN SIGNAL LEVER ,( ITS LIKE ITS GROUNDED TO IT) IT CLICKS WHILE IM DRIVING TOO
:???:
Pizzon
02-07-2007, 04:32 PM
Did you replace the ignition SYSTEM or just the switch? (where you put yer key into)
DUSTIN4537
02-07-2007, 04:51 PM
JUST THE SWTCH..I AM TRING SECURITY RELEARN PROCEDURE
In the event that your vehicle fails to start after installing the DHP 1.0 PCM, you will need to perform the Security Relearn Procedure. This procedure allows the PCM to function properly in your vehicle. Follow the steps listed below completely.
Attempt to start the car by turning the key to the Start/Run Position.
Observe that the vehicle fails to start and that the security light is illuminated.
Release key to the 'ON/Accessory' Position. (DO NOT turn key to the 'off' position.)
Allow the vehicle to sit with the key in the 'ON/Accessory' Position for no less than 11 minutes.
Turn key to off position and allow the vehicle to remain in the 'OFF' position for no less than 30 seconds.
Repeat #1 - #5 for 3 cycles.
On 4th attempt, car should start.
NOTE : Since this is a fairly long procedure, I would limit all electrical sources, such as disconnecting headlights, to prevent discharge of battery.
NOTE 2 : It is SAFE to wait LONGER than the allotted time, but it is not safe to wait less time. I.e. 12 minutes instead of 11 minutes should be safe; however, waiting 10 minutes instead of 11 minutes is not safe.
Properly executed, this procedure should take approximately 35 minutes to complete.
Pizzon
02-07-2007, 05:38 PM
SOunds good to me... just make sure you wired the ignition switch completely well. i had a cavilier RS that was realy jacked up on ignition wise. Had to take the key halfway out while driving and move it forword to use turn signals and windsheild whipers... and radio. lol
rixGAphx
02-07-2007, 06:34 PM
Originally posted by Pizzon
i had a cavilier RS that was realy jacked up on ignition wise. Had to take the key halfway out while driving and move it forword to use turn signals and windsheild whipers... and radio. lol Yew paid extra for that feature when you bought the 'RS' option upgrade.
RS = Really Stoopid.
:D :D
vBulletin® v3.7.2, Copyright ©2000-2008, Jelsoft Enterprises Ltd.