Headlights wont come out..

[Gixmo]

So I followed the FAQ (Before anyone asks, I'm pretty experinced at ripping cars apart...This isn't my first)...

The FAQ indicates you remove the RAM AIR shroud which I've done

I see the two tabs, They both are SOLID.. The one closest to the engine on teh drivers side jiggles around, but thats it

The 2 10MM bolts above, Doesnt look like I need to remove those - However, The clips simply do NOT come up. All I am looking to do is replace a burnt out headlight.

Suggestions? - '03 GA GT

[kody]

http://www.gaownersclub.com/forum/showthread.php?threadid=101

[jcasemore]

The tabs have little bumps on the front side which engage into slots. It's hard to explain the motion you need to remove them... You have to basically pull the top of them towards the rear of the car to bend them and get the bumps out of the slot. I find if you take a pair of channel lock pliers, grab the horizontal part and push towards the rear of the car while pulling upwards they will release...

Good Luck

[tenspeed]

The speed clip has a protrusion that keeps it in place. You have to pry it towards the rear while pulling up to get it to pull up.

[Gixmo]

Originally posted by kody
http://www.gaownersclub.com/forum/showthread.php?threadid=101

Gee Thanks, I didn't post that out in the very first line of my original post.....

Casemore/Tenspeed - Exactly what I needed. My fear was the nubs were plastic in nature, and I didn't want to force it out.

Cheers!

[kody]

Originally posted by Gixmo
Gee Thanks, I didn't post that out in the very first line of my original post.....

Geez, sorry to upset you :tears2: