CAI question

[Nitr0Racing21]

How can I get my CAI in the fenderwell for my 98 GAGT is it the same as the 99+'s?

[lvemy3100]

if you use the directions found in the following thread you should be able to use a 99-05 GA intake http://www.gaownersclub.com/forum/showthread.php?s=&threadid=45799

..at least that is what i have been told a few times in the past

[Matt95GT]

http://www.gaownersclub.com/forum/showthread.php?t=45799

[nice96gt]

:thumbup2:

[Nitr0Racing21]

How easy is it to bend that piping?

Also can I buy a 99+ intake system, whats the difference doesnt look like there is one?

[Jordon'sGrandAm]

i don't know maybe diff tubein size not sure.

[nice96gt]

How easy is it to bend that piping?

Also can I buy a 99+ intake system, whats the difference doesnt look like there is one?

You can't bend it...you have to buy it like that. You did "read" the how to right??? All of the info and answers to questions you may have are in there. This is a 92-96 Prelude cold air intake (must be 2-piece unless you want to do even more cutting) and was modified to fit. The hole going into the fender was also modified since the tubing is 3". 99+ have a huge ass hole so that's why it's easier for them to run the piping through into the fender. You could try to use a 99+ intake since the 3100 and 3400 are practically the same setup, but I can't promise you it will work without any snags. Basically you need 2 main pieces. An L bend and a small curve. So really you can use any intake if you can get the parts.

Re-read the how-to if you are going to make your own and then do your research before you buy anything...Unless you have a better way to do it, then go for it.

[lvemy3100]

Mandrel Bent Tubing- http://www.mpracing.org/store/index.php?act=viewCat&catId=86

Straight Tubing- http://www.mpracing.org/store/index.php?act=viewCat&catId=88

3-ply Silicone Couplers- http://www.mpracing.org/store/index.php?act=viewCat&catId=63

S&B Inverted cone air filters- http://www.mpracing.org/store/index.php?act=viewCat&catId=99