Problems

[graden]

Well after rebuilding the engine, getting a 5 speed tranny and thinking it was all over..... think again. Im being held up by a dam fly wheel. I cant find a fly wheel that will work with a 3300. The bolt pattern on a fly wheel for the 2.2 , 2.8 and 3.1 are all wrong :tears: I tryed to get a shop to drill holes in the 2.2 fly wheel to match up with the 3300 bolt pattern and thay wont touch it. I wounder if a fly wheel from a 3.4 will work but I cant find a 3.4 to compare with. G.M or any tranny shops dont carrie them and the wreckers said the engine with a 5 speed is to rare and thay would not have 1. Im at a loss. I need some brain storming ideas

[graden]

I found a solution:P .. all this time my buds dad is a metal worker. he had a look at it this weekend and said he would do it.
so hopefuly he can build it and it will happen.

[red93gagt]

did it work? you gotta keep us all informed. I want a 5 speed V6 too! I'll never get it, but I still want one.

later
kurtis

[graden]

i called him this weekend..... bad time for 1 of his mech to have a nervious break down:mad: .. but he says this week for sure

[graden]

:bounce: :bananna: :party2: :headbang: :flash: Finaly I got my fly wheel back from the meck shop... HUSTON WE ARE READY TO COMENCE!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

[computerboy2k1]

cool, yeh i only see 1 1992/1993 grand am with a v6 and a 5 speed in the papers like every 2 months or so. This setup is so rare but must be ****en fast.

[graden]

just an update on pontiac.... lol thay never made a 3300 with a 5 speed. Thats why i needed to get a fly wheel custom made. If you see 1 in the paper, prolly its ppl that dont know what thay have. or its a misprint