gem
04-01-2008, 03:21 PM
http://www.gaownersclub.com/forum/showthread.php?s=&threadid=42552
<<<< picture of the back wall with plug in center and blower fan at top>>>>
<<<<followed by this statement>>>>>>>
"Now, get your self a 1/4" drive ratchet and a 8MM socket... i think... or use whatever fits and remove the two bolts holding in the resistor. The one in the back that you can't see is the most difficult. "
<<<<Addendum>>>>>>
In the picture you see the blower fan in the top of the picture and you can see 2 (of the 3) 1/4" bolts that hold the fan in.
If you remove these 3 blower fan bolts, the fan drops straight down and the entire wall with the plug is completely visable and easily available. You don't have to stretch or lay upside down in the seat. The job of changing out the resistor is much simpler.
After the resistor change, the 3 bolts into the blower motor are easy to replace.
<<<< picture of the back wall with plug in center and blower fan at top>>>>
<<<<followed by this statement>>>>>>>
"Now, get your self a 1/4" drive ratchet and a 8MM socket... i think... or use whatever fits and remove the two bolts holding in the resistor. The one in the back that you can't see is the most difficult. "
<<<<Addendum>>>>>>
In the picture you see the blower fan in the top of the picture and you can see 2 (of the 3) 1/4" bolts that hold the fan in.
If you remove these 3 blower fan bolts, the fan drops straight down and the entire wall with the plug is completely visable and easily available. You don't have to stretch or lay upside down in the seat. The job of changing out the resistor is much simpler.
After the resistor change, the 3 bolts into the blower motor are easy to replace.