Switches

[ScathDeSolas]

Okay I want to run a switch to my interior from the engine bay. I dont know where the hell to drill or if I cant drill where to run the wires. I know on my old car I ran them through the fender. I dont see how that's possible with my 95 GT. Any ideas or solutions are helpful

[roksoc]

There should be or at least in my car 99+ there is a hole with a grommet in the firewall where you can run wires through.

[ScathDeSolas]

Do you have a picture? I just went out there and at the top right it looks as if someone drilled into the grommet or something But I dont know where it goes to.

[roksoc]

I don't have a pic right now but I'll snap one tomorrow when I get a chance.

[Matt95GT]

There are no easy holes or wiring grommets on the 92-98.

I drilled next to the hood release cable.
http://fazeshift.org/pics/albums/userpics/10001/normal_Dcp00522.jpg

http://fazeshift.org/pics/albums/userpics/10001/normal_Dcp00521.jpg

[Jibo]

Question: what is the switch going to be used for? is it not just possible to grab a power or constant 12v signal from inside the cab already? might save you a headache...

[ScathDeSolas]

Well I want to connect multiple switches. Headlight strobes, etc. Just random lighting I'll be doing. Underbody kit. How do I get this grommet off and where does the wire drop down into? Will it be easily seen?


Thanks I did it